P0090: Fuel Pressure Regulator 1 Control Circuit
P0090 means the engine computer sees a problem in the circuit that controls the fuel pressure regulator, so it cannot accurately command fuel pressure. The most common fix is repairing wiring, a connector, or replacing the fuel pressure regulator or control valve, which typically costs about $150 to $500.
- Severity
- Moderate
- Can I drive?
- Drive with caution
- DIY?
- Possible with some experience
- Repair cost range
- $50 – $1,200
Get the answer for your exact car
Add your car and a few details. DashClue asks up to 3 questions, then tells you the most likely cause and what it should cost.
FreeNo card neededAnswer in about 2 minutes
What does P0090 mean?
The fuel pressure regulator helps keep fuel pressure at the level the engine needs. On many vehicles, the computer controls that regulator with an electrical circuit, and P0090 sets when the computer sees that circuit open, shorted, or otherwise not working correctly. If fuel pressure is too low or too high, the engine may run poorly, stall, or be hard to start. The exact part involved can vary by vehicle, but the fault is usually in the regulator circuit, the wiring, or the regulator itself.
Common symptoms
- Check engine light on
- Hard starting
- Cranks but won't start
- Rough idle
- Loss of power when accelerating
- Poor fuel mileage
Causes, fixes and costs
P0090: Fuel Pressure Regulator 1 Control Circuit
General guide for most cars. Your car may differ.
The car may still run, but incorrect fuel pressure can cause stalling, poor power, or no-start conditions. Stop driving if the engine stalls, will not start, or the fuel pump sounds unusual and the car runs extremely rough.
Most likely causes
- 1
Damaged wiring or connector at the fuel pressure regulatorHigh
Intermittent running, hard starting, or a no-start with a check engine light often points to an open circuit, corrosion, loose pins, or rubbed-through wiring. Symptoms that change when the harness is moved are a strong clue.
Quick check: Inspect the regulator connector and nearby harness for broken wires, corrosion, bent pins, or loose fit. Wiggle-test the connector with the engine idling if it runs.
- 2
Faulty fuel pressure regulator or electronic control valveHigh
If the wiring looks good but fuel pressure is still wrong, the regulator or its internal solenoid may be stuck or electrically failed. Rough idle, hard starts, and lack of power are common signs.
Quick check: Use a scan tool and fuel pressure test to compare commanded pressure with actual pressure, or test the regulator circuit resistance and power supply.
- 3
Blown fuse, bad relay, or power/ground problemMedium
A regulator circuit that has no power or ground can set P0090 and may cause a crank-no-start or stalling condition. This is more likely if the problem appeared suddenly after other electrical issues.
Quick check: Check related fuses and relays, then verify battery voltage and ground at the regulator connector with a test light or multimeter.
- 4
Engine computer driver issueLow
If all wiring, power, ground, and the regulator test good, the control side in the PCM may be faulty. This is less common and usually considered after other causes are ruled out.
Quick check: Confirm the circuit tests and compare live data; if the command signal is missing despite good inputs, a professional diagnostic is needed.
Can you fix it yourself?
Possible with some experience
Difficulty: Moderate. A basic inspection of the connector, wiring, fuses, and grounds is a reasonable DIY job with a scan tool and multimeter. Replacing the regulator or diagnosing the control circuit further may require fuel system knowledge and the right pressure-testing tools.
Show the stepsHide the steps
- Scan for related codes and note fuel pressure data if available.
- Inspect the regulator connector and wiring for damage or corrosion.
- Check the related fuse and relay.
- Verify power and ground at the regulator connector.
- Test the regulator control signal and compare commanded vs. actual fuel pressure.
- Repair wiring or replace the faulty regulator as needed.
- Clear the code and road test.
- Recheck for returning codes and pressure problems.
Estimated repair cost
$100 – $300
Inspect and repair fuel pressure regulator wiring: diagnostic time plus minor wiring repair
- Fuel pressure regulator or electronic control valve replacement$150 – $500
- Fuse, relay, or connector repair$50 – $200
- PCM diagnosis and replacement programming$300 – $1,200
Prices vary by vehicle, engine layout, and local labor rates; dealer-only or hard-to-reach parts can cost more.
Frequently asked questions
Can I drive with code P0090?
Usually you can drive a short distance if the engine runs normally, but it is best to get it checked soon. If the engine stalls, struggles to start, or loses power, do not keep driving.
Will P0090 cause a no-start?
Yes, it can. If fuel pressure is too low or the regulator circuit fails completely, the engine may crank but not start.
Is P0090 an engine code or a fuel system code?
It is an engine-related OBD2 code, but the problem is in the fuel pressure control circuit. The fault may be electrical, mechanical, or both.
Can a bad fuel pump set P0090?
Sometimes, but P0090 points more directly to the regulator control circuit than the pump itself. A weak pump can create fuel pressure problems, so a full fuel pressure test is important.
Can I clear P0090 without fixing it?
You can clear it, but the code will usually come back if the fault is still there. Clearing the code does not repair the wiring, regulator, or control problem.
Related codes
Related problems
This guide covers most cars and is general advice, not an inspection. Prices are typical US independent-shop ranges and vary by region, car and shop. If your brakes, steering or a warning light feel unsafe, stop driving and contact a mechanic.